Pulsonix User Forum

Technical advice from Pulsonix engineers and the wider community.

 All Forums
 Help with using Pulsonix
 Manufacturing outputs
 Print to PDF - positioning

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List

* Forum Code is ON

   Upload a file

Check here to subscribe to this topic.

T O P I C    R E V I E W
kunalagon Posted - 14 May 2015 : 07:59:53

I am trying to change position when printing to PDF from center to any other part of the A4 paper (upper center, upper left, bottom right etc, etc.), But I am not able to see that option in printing to pdf. Is this possible, anyway?

thank you
3   L A T E S T    R E P L I E S    (Newest First)
steve Posted - 14 May 2015 : 10:37:36
Have you defined the PDF document size, otherwise it sizes to fit?

Pulsonix Assistance
kunalagon Posted - 14 May 2015 : 09:34:03
whatever I choose it still prints on the center of the A4 paper(in pdf it prints only board area size pdf document)
steve Posted - 14 May 2015 : 09:20:49
Yes this is possible. For each cam plot output, the Design Position choice will allow you to place it Centre, Lower left, Origin, Upper Left or anywhere by the use of X,Y, if not choosing to use Auto Shift.

Pulsonix Assistance