Pulsonix User Forum

Technical advice from Pulsonix engineers and the wider community.

Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Help with using Pulsonix
 PCB Design
 Current Grid bert, fred, harry?
Author Previous Topic Topic Next Topic  

trayres

USA
15 Posts

Posted - 14 Dec 2015 :  00:04:18  Show Profile  Reply with Quote
...not sure where those came from?

steve

United Kingdom
316 Posts

Posted - 14 Dec 2015 :  10:10:49  Show Profile  Reply with Quote
These crept in from a training session but will not be in the next release of data

Pulsonix Assistance
Go to Top of Page

trayres

USA
15 Posts

Posted - 15 Dec 2015 :  07:46:27  Show Profile  Reply with Quote
...HAHAHAHA

I thought it was some kind of Easter Egg that only occurred to people who didn't use technologies/grids in a good way (which I know I'm sub-optimal at).

Go to Top of Page

steve

United Kingdom
316 Posts

Posted - 15 Dec 2015 :  08:23:52  Show Profile  Reply with Quote
:) No just one of those problems that can occur when covering training and data generation on the same machine!

On a serious note I would always recommend managing technologies otherwise they can become out of control. I drum this home during the training sessions.

Pulsonix Assistance
Go to Top of Page

trayres

USA
15 Posts

Posted - 24 Dec 2015 :  16:36:39  Show Profile  Reply with Quote
I wish I was better at it; there are a million tricks I haven't picked up yet, but all your training sessions are in the UK - I'm in California!
Go to Top of Page
  Previous Topic Topic Next Topic  
Jump To: