Pulsonix User Forum

Technical advice from Pulsonix engineers and the wider community.

Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Help with using Pulsonix
 Simulation
 Laplace device with parameters
Author  Topic Next Topic  

pdr

Netherlands
12 Posts

Posted - 21 Sep 2018 :  16:45:22  Show Profile  Reply with Quote
Hi.

I am trying to do a (control loop) simulation with laplace devices.
In these devices you can use equations to define its behaviour.
I would like to enter values in these equations by means of the .param simulator control.
However, this makes the simulator abort with a syntax error.

When I look at the generated spice netlist, I see that the .param name is copied within the quotes and not replaced by the actual value

.subckt $$LaplaceLAP2 INP OUTP
A1 INP OUTP Laplace
.model Laplace s_xfer laplace="{Kdc}/(12*s+1)" denormalized_freq=1
.ends

Is there any way to make this work ?

Jochen

Germany
8 Posts

Posted - 26 Sep 2018 :  13:46:07  Show Profile  Reply with Quote
Hi,

the Pulsonix Spice Manual states that the Laplace model can only work with numerical constants like 1.234. Parameters are not mentioned, so i assume they are just not supported there.

Jochen
Go to Top of Page
   Topic Next Topic  
Jump To: