i know the "disconnect from vault" function when copying out designs from vault.
but after some confusings and misactions i now have a design sch and pcb that i want to check into vault. this design is a new design as an increment of an existing design in the vault, was copied out but not disconnected.
so the new design has the vault id from the old design and as a result i cannot check in the new design as a new design because it has already a vault id. the error is "vault id xyz is not checked out".
is there a possibility for the existing sch and pcb to disconnect it from vault, i.e. get rid of the vault id to be able to check them into vault as a new design?