Pulsonix User Forum

Technical advice from Pulsonix engineers and the wider community.

 All Forums
 Help with using Pulsonix
 Custom Pads....

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List

* Forum Code is ON

   Upload a file

Check here to subscribe to this topic.

T O P I C    R E V I E W
uslimey Posted - 08 Mar 2017 : 16:46:52
I recently transitioned from Easy PC to Pulsonix... One of the main reasons was te be able to define custom pad shapes which was a real bear with Easy PC.... So, here's todays problem... My interposer pad comprises of a relatively large, round, surface mount pad, coupled with a small, offset via... I was able to define this by defining the via'd section with the <Default Shape> layer, and the surface mount part defined with as TOP layer... This was great... It appeared to do everything I need... It put a large pad on the Top and small pads on all other layers... I say, 'this was great' because it was until I mirrored my part in my assembly... Everything flipped to the other side except the surface mount pad...

Any help would be appreciated!
2   L A T E S T    R E P L I E S    (Newest First)
uslimey Posted - 09 Mar 2017 : 15:12:18
Thanks, that worked... However, it highlighted another issue...

For some reason , despite the silkscreen and surface mount parts of the pads being on the underside, the online DRC thinks the component is on the top side of the board...

Moreover, if you make through hole and bottom layer non selectable, the component does dim, however, it is still selectable.

I am trying to place decoupling caps as close to my power pins as possible... the decoupling caps are on the top side... I did disable the DRC but can't seem to find away of stopping the random selection of my component.
psxforum Posted - 09 Mar 2017 : 09:03:08
If you go to Setup, Design Settings, General, there is a checkbox under Pad Exceptions called "Mirror With Component". From your description, I suspect that this is not checked, which is why it does not take your Exception pad shapes over to the back of the board when you mirror the component.