Pulsonix User Forum

Technical advice from Pulsonix engineers and the wider community.

Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 Help with using Pulsonix
 Manufacturing outputs
 Print to PDF - positioning
Author Previous Topic Topic Next Topic  

kunalagon

Yugoslavia
15 Posts
Posted - 14 May 2015 :  07:59:53  Show Profile  Reply with Quote
Hello,

I am trying to change position when printing to PDF from center to any other part of the A4 paper (upper center, upper left, bottom right etc, etc.), But I am not able to see that option in printing to pdf. Is this possible, anyway?

thank you

steve

United Kingdom
316 Posts
Posted - 14 May 2015 :  09:20:49  Show Profile  Reply with Quote
Yes this is possible. For each cam plot output, the Design Position choice will allow you to place it Centre, Lower left, Origin, Upper Left or anywhere by the use of X,Y, if not choosing to use Auto Shift.

Pulsonix Assistance
Go to Top of Page

kunalagon

Yugoslavia
15 Posts
Posted - 14 May 2015 :  09:34:03  Show Profile  Reply with Quote
No
whatever I choose it still prints on the center of the A4 paper(in pdf it prints only board area size pdf document)
Go to Top of Page

steve

United Kingdom
316 Posts
Posted - 14 May 2015 :  10:37:36  Show Profile  Reply with Quote
Have you defined the PDF document size, otherwise it sizes to fit?

Pulsonix Assistance
Go to Top of Page
  Previous Topic Topic Next Topic  
Jump To: