I woud like to best use advanced router in the following case: I have a power track that supply many LED strings , the main power bus needs to carry 1A (so… let’s say 0.5mm width) but each string carries 20mA (for example 0.15mm) . How can I configure Pulsonix to automatically define different size of the same net when I start to manual or to auto-route a track. This situation is very common in each design in which there is a main power track and single devices that sink a little current. Any suggestion?
It seems that my request it's a little bit assumptive...or maybe i was not so clear :). It would be very useful to add an attribute to specific pad (or pin) of a component so that size rule can be overridden for a segment of a certain lenght (or something similar ideas) . Is that possible? Or maybe adding a starpont ... but this solution seems to be very Tricky to manage...
Posted - 11 Mar 2015 : 09:23:33
