Note: You must be registered in order to post a reply. To register, click here. Registration is FREE!
T O P I C R E V I E W
poorchava
Posted - 05 Aug 2019 : 21:46:13 I have a design, where I have 3 different alternative sensor components. Footprints are such, that they can be placed pretty much one on top of another int he same space, which is obviously not a problem, since only one of them will be installed in a given product variant.
Is there a way to disable / add an exception for component-to-component spacing check for particular components?
1 L A T E S T R E P L I E S (Newest First)
Olaf
Posted - 08 Aug 2019 : 20:20:41 I think that this is a typical case for the use of variants. Just set up 3 variants. Each sensor is fitted in one variant. You should get no comp-to-comp errors then, even if the sensors overlap.