Note: You must be registered in order to post a reply. To register, click here. Registration is FREE!
T O P I C R E V I E W
marco.ruggeri
Posted - 27 Feb 2015 : 07:59:04 Is it possible to automatic place snap point with constant pitch along a curved segment?
3 L A T E S T R E P L I E S (Newest First)
steve
Posted - 27 Feb 2015 : 09:16:02 Assuming this is on the board outline that was imported, you would have to add something to its originating form and read it into Pulsonix as say DXF, then use construction lines to pick up on those points
Pulsonix Assistance
marco.ruggeri
Posted - 27 Feb 2015 : 08:52:27 i have a complex polyline with many segments with different angle , so it seems it doesn't work. How can i do?
steve
Posted - 27 Feb 2015 : 08:43:24 You can achieve this by using construction lines from the arc center
