Pulsonix User Forum

Technical advice from Pulsonix engineers and the wider community.

Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 Help with using Pulsonix
 PCB Design
 Snap point along a curved segment
Author Previous Topic Topic Next Topic  

marco.ruggeri

Italy
67 Posts
Posted - 27 Feb 2015 :  07:59:04  Show Profile  Reply with Quote
Is it possible to automatic place snap point with constant pitch along a curved segment?

steve

United Kingdom
316 Posts
Posted - 27 Feb 2015 :  08:43:24  Show Profile  Reply with Quote
You can achieve this by using construction lines from the arc center

Pulsonix Assistance
Go to Top of Page

marco.ruggeri

Italy
67 Posts
Posted - 27 Feb 2015 :  08:52:27  Show Profile  Reply with Quote
i have a complex polyline with many segments with different angle , so it seems it doesn't work. How can i do?
Go to Top of Page

steve

United Kingdom
316 Posts
Posted - 27 Feb 2015 :  09:16:02  Show Profile  Reply with Quote
Assuming this is on the board outline that was imported, you would have to add something to its originating form and read it into Pulsonix as say DXF, then use construction lines to pick up on those points

Pulsonix Assistance
Go to Top of Page
  Previous Topic Topic Next Topic  
Jump To: