Pulsonix User Forum

Technical advice from Pulsonix engineers and the wider community.

 All Forums
 Help with using Pulsonix
 PCB Design
 Current Grid bert, fred, harry?

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON

   Upload a file

Check here to subscribe to this topic.
   

T O P I C    R E V I E W
trayres Posted - 14 Dec 2015 : 00:04:18
...not sure where those came from?
4   L A T E S T    R E P L I E S    (Newest First)
trayres Posted - 24 Dec 2015 : 16:36:39
I wish I was better at it; there are a million tricks I haven't picked up yet, but all your training sessions are in the UK - I'm in California!
steve Posted - 15 Dec 2015 : 08:23:52
:) No just one of those problems that can occur when covering training and data generation on the same machine!

On a serious note I would always recommend managing technologies otherwise they can become out of control. I drum this home during the training sessions.

Pulsonix Assistance
trayres Posted - 15 Dec 2015 : 07:46:27
...HAHAHAHA

I thought it was some kind of Easter Egg that only occurred to people who didn't use technologies/grids in a good way (which I know I'm sub-optimal at).

steve Posted - 14 Dec 2015 : 10:10:49
These crept in from a training session but will not be in the next release of data

Pulsonix Assistance