The Statistics page on the Document Properties is used to report the document properties of the current open design. These are not user editable.
These properties can be added to the design using system attributes (attributes shown in brackets in the drop down list) from the Insert Attribute dialog. Once in the design, they can be extracted to a user report using the Report Maker option.
Shortcuts
Default Keys: None
Command: Document Properties
Locating this option
Available from: File menu > Document Properties > Statistics tab
Using The Dialog
Last Saved By - Displays the name of the author who last saved the design.
Revision Number - This is the number of times the design has been saved.
Total Editing Time - Total editing time calculated from all the time the design has been active. Use the Reset button to set this back to zero.
The edit time is worked out by the amount of time the design has been open previously (saved into the design) plus the amount of time it has been open this session. When the Reset button is pressed it resets the saved value to 0 but it still adds the amount of time it’s been open that session.
Last Printed - The last time the design was printed.
Created - The date and time that the design was created.
Last Saved - This was the last time the design was saved.
Signature - Indicates if the design has a fault - 6 zeros indicates there are no faults (0 0 0 0 0 0). If this sequence shows another other number than zero then please contact Technical Support.
Use the Update button if you wish to do a normal design verify where it updates the signature to manually check for errors.
Enable Dynamic Checking - Use this when instructed by Technical Support to Enable Dynamic Checking.
Verify Design on Save
Select this for verifying the design whenever a save is performed (note: this is only Save and not on a Save As). On large designs this can significantly slow down saving if verifying takes a while. Use the Use Dynamic Verify Settings switch to only check for the Dynamic Verify faults instead of every fault if you wish. This can help speed it up.