Where ‘extents’ can be reported, the Values drop down list box will display a number of choices. This selection will be applied to the coordinate types available next to the Use: radio buttons. These coordinates are reported in the designs current units or using the coordinates selected in the Coordinates command.
Area
Using this value will report the total area extents. There is no choice of coordinates.
Bottom Left
This reports the Bottom Left coordinate of the extents. If the board outline or any other shape has been used for the extents, the value reported will also include the thickness of the outer edge of the shape not the centre line.
Coordinate types of X or Y or (X,Y) can be chosen for the report.
Centre
This reports the Centre coordinate of the extents.
Coordinate types of X or Y or (X,Y) can be chosen for the report.
Height
This reports the total length of the extents in the vertical plane (Y).
Top Right
This reports the Top Right coordinate of the extents. If the board outline or any other shape has been used for the extents, the value reported will also include the thickness of the outer edge of the shape not the centre line.
Coordinate types of X or Y or (X,Y) can be chosen for the report.
Width
This reports the total length of the extents in the horizontal plane (X).